INTRODUCTION
Overview
In addition to auto-routing, Proteus PCB Layout includes support for auto-placement. At its simplest level you can simply run the Auto-placer command and let it place the components on whichever side of the PCB you specify. In more typical use you would create groups of components in Design Explorer (e.g. POWERSUPPLY, FILTER, USBCONN) and then place those groups inside placement rooms on the layout.
In either case, it is important to think of auto-placement as a timesaver. It is intended to put all of your parts on the correct side and region of the PCB; in no way is it designed to put parts in their final position on the board.