SIMULATOR GADGETS

Introduction

The interface to the ProSPICE simulator makes use of a family of special objects which you place on the schematic alongside the circuit itself. None of them forms part of the circuit and none of them reaches the PCB: they exist to stimulate the design, to measure it, or to display what happened when it ran. Each has its own entry in the Simulation Modes group of the Mode Selector toolbar, and each is covered in depth in the Proteus VSM documentation.

Graphs

A graph is placed on the drawing like any other object and holds the results of a simulation. You give it an analysis type when you place it, add traces to it from probes, generators and nets, and then run it to produce the waveforms. A graph can be maximised to a full screen window for cursor based measurement of the traces it carries.

See Also:

Graph Objects (VSM)

Generators

A generator attaches to a single wire or pin and drives it with a stimulus for the duration of the simulation. The analogue types cover DC, sine, pulse, exponential, single frequency FM, piece-wise linear, file and audio sources; the digital types cover fixed states, single edges, pulse trains, clocks and patterns. A scriptable generator is also provided for waveforms you want to describe yourself.

See Also:

Generators (VSM)

Probes and Tapes

A probe records the value at the point where you place it, so that it can be plotted on a graph or read off during an interactive simulation. A voltage probe attaches to a wire and records a voltage or a logic state, whilst a current probe is placed in line with a wire and records the current flowing through it. The third probe type is the tape recorder, which captures the signals crossing the boundary of a partitioned design so that they can be played back into a later simulation of the neighbouring partition.

See Also:

Probes (VSM)

Tapes and Partitioning (VSM)

Virtual Instruments

A virtual instrument is a piece of test equipment drawn on the schematic and wired into the circuit exactly as its real counterpart would be, and it opens its own front panel when the simulation runs. The set placed from the Object Selector includes an oscilloscope, a logic analyser, a counter/timer, a virtual terminal, SPI and I2C debuggers, a signal generator, a pattern generator, DC and AC voltmeters and ammeters, and a wattmeter.

See Also:

Virtual Instruments

Active Popups

An active popup marks out a rectangular area of a root sheet, which is then shown as a live window inside VSM Studio while you debug your firmware. This lets you watch that part of the circuit, and operate any actuators in it, without leaving the software debugging environment. Active popups can only be defined while the simulation is stopped.

See Also:

Active Popups (VSM Studio)