TEMPERATURE MODELLING

Specifying a Temperature

The SPICE3F5 kernel provides extensive support for modelling the effects of temperature. The scheme operates as follows:

  • There is a global property TEMP, which will, if nothing else is done, apply to all components in the circuit. It defaults to 27 degrees Celsius and appears on the Temperature tab of the simulator options dialogue as Operating temperature.
  • The temperature of individual components can be specified by giving them their own TEMP property, which is how you model one device running hot in an otherwise ambient circuit.
  • Where parameters for a device model vary according to the temperature at which they were measured, this temperature can be specified globally and/or individually by TNOM properties. TNOM also defaults to 27.

Which Devices Respond to Temperature

Temperature modelling is provided for resistors, diodes, JFETs, MESFETs, BJTs, MOSFETs at levels 1, 2, 3 and 6, BSIM MOSFETs, and both lossy and lossless transmission lines.

It is equally worth knowing what does not respond, because the omissions are not the ones people expect:

  • Inductors have no temperature dependence at all.
  • Neither switch type has any temperature dependence, whether voltage controlled or current controlled.
  • No digital primitive reads the temperature, so nothing on the digital side of a mixed mode simulation is affected by it.

BSIM devices deserve a note of their own. All three BSIM levels do have temperature routines, so the simulator will apply TEMP to them. The caution is a modelling one rather than a simulator one: BSIM parameter sets are normally extracted from measurements taken at one specific temperature, so the set you use should be one characterised near the temperature you intend to operate at. Moving a long way from the extraction temperature will give you a result, but not necessarily a trustworthy one.

More generally, it is very important to realise that most equivalent circuit models for ICs will not model temperature effects correctly. This is because such models usually use ideal controlled sources and other macro modelling primitives, rather than containing an exact replica of the device internals. Once such primitives are used, it is unlikely that the model will show correct temperature dependent behaviour unless someone has taken the trouble to make it do so.

The Thermal Voltage

PROSPICE derives a further design property from TEMP for the benefit of schematic model authors. Unless the design already defines it, VTHERM is set to the expression

(TEMP+273)*8.6173468e-5

which is the thermal voltage in Volts at the circuit's operating temperature. A model that needs it can reference VTHERM in its own property expressions and will then track any change the user makes to TEMP, rather than having the constant compiled into the model.

See Also:

Simulator Options Reference

Using SPICE Models