ABOUT THE DOCUMENTATION

This manual is intended to complement the information provided in the context-sensitive help and in the practical tutorials. Whereas the manual contains background information, the tutorials contain a practical walkthrough of the software and the context-sensitive help provides specific information on a dialogue form.

Pressing F1 opens the Schematic Capture manual; the Help Menu > Simulation Help command opens this one. Simulation Help has no keyboard shortcut of its own. To read the help for a particular component, point at it and press CTRL+H. Dialogue forms carry their own Help button.

The reference pages for the simulation dialogue forms are published in the Schematic Capture manual rather than in this one, and each form reaches its own page through the Help button on the form itself.

Proteus VSM can be used in two rather distinct ways, either for Interactive Simulation or for Graph Based Simulation, and this is reflected in the structure of the manual. Typically, you will use interactive simulation to see if a design works at all, and graph based simulation to investigate why it does not or to take very detailed measurements. However, there are no hard and fast rules. Some elements of the system, such as Generators, are relevant to both modes of use and are given their own chapters for this reason. Graph based simulation, together with the analysis types that go with it, requires the Advanced Simulation Features module of the Proteus Design Suite.

Graph Based Simulation

The remainder of the manual is organised as follows:

  • Interactive Simulation, running a design in real time from the animation control panel, working with indicators and actuators, taking measurements and controlling the animation timestep.
  • Instruments, the virtual instruments you can place on the schematic, including the oscilloscope, the logic analyser, the protocol debuggers, the terminals and the meters.
  • Working with Microprocessors, simulating and debugging firmware, covering the source code window, breakpoints, the watch window, popup windows and the diagnostic tools.
  • Graph Based Simulation, placing graphs on the schematic, adding traces to them and running the simulations that populate them.
  • Analysis Types, a reference section describing each type of graph and the analysis behind it.
  • Generators and Probes, the signal sources and measurement points used by both modes of simulation.
  • Scriptable Generators, writing EasyHDL scripts to generate stimulus that the standard generators cannot produce.
  • Using SPICE Models, attaching manufacturers' SPICE models and subcircuits to schematic parts.
  • Advanced Topics, temperature modelling, initial conditions, ground and power rails, partitioning, simulator control properties and the types of simulator model.
  • Troubleshooting, the simulation log and what to do about the errors reported in it.

Two of these books are complete manuals in their own right, embedded inside this one. Instruments documents the virtual instruments, and VSM Studio, which sits inside the Working with Microprocessors book, documents the integrated development environment.

Proteus also includes the ProPilot and ProTutor AI assistants, which can advise on a design and help you to interpret the results of a simulation. The EDAi manual documents them in full.

See Also:

Proteus VSM : Interactive Simulation/Debugging (Tutorial)

Proteus VSM : Graph Based Simulation (Tutorial)

Proteus VSM : Getting Started with a New Project (Tutorial)

Proteus VSM : Importing an Existing Project (Tutorial)

EDAi : ProPilot and ProTutor

VSM SDK : Developing Your Own Models