PROTEUS PLAYKIT
Introduction
Proteus Playkit is a hardware product designed especially for use with IoT Builder and Visual Designer so that we can offer educators an affordable, plug and play hardware platform for students to use alongside the Proteus software.
See Also:
IoT Builder Compatible Hardware
The complete Playkit consists of two boards as shown below

The PlayKit Controller Board.

The Playkit Peripherals Board mounted on top of the Controller board.
Controller Board
The controller board is essentially an Arduino Uno with an ESP8266 wi-fi controller chip connected to the UART.
- Standard Uno form factor.
- ATmega328P main processor
- Fully compatible with all Arduino Shields and Grove Peripherals.
- Pre-programmed ESP8266 wi-fi/IoT processor for use with Proteus IoT Builder.
- Switch selectable Uno or IoT builder operation modes
Peripherals Board
The peripherals board is a standard Arduino Shield offering a pre-connected set of modules for use in student experiments.
- 3 push buttons
- Tri-colour LED
- DHT11 Humidity Detector
- DC Motor
- IR (pet) detector
The major advantages of Playkit over Arduino alternatives are cost, and compatibility. Both the Arduino Yun and the Seeduino Cloud products use the ATmega32U4 which has different on board peripherals from the ATmega328P and so not all shields designed for the Arduino Uno will work with them.