JUNCTION DOTS

Introduction

Junction dots are used to mark interconnection between wires. In general, Proteus will place and remove them automatically but it is sometimes useful to place a dot at a specific position and then route wires to and from it.

Wires which touch or cross are never considered connected unless there is a dot at the point of contact. Conversely, where there is a dot, there will always be a connection unless you have contrived to superimpose wires and dots by dragging or moving them into contact with each other.

You can customise the appearance of junction dots by editing the WIRE DOT graphics style. See Global Styles for more information.

You can also set the size and shape of junction dots with the Set Junction Dot Style command on the Template menu. Three shapes are available: square, round or diamond. See Set Junction Dot Style for details of the controls on the dialogue form.

Placing Junction Dots

To place a dot:

  1. Select Junction dot icon from the Mode Selector Toolbar.
  2. Point where you want the dot to be placed in the Editing Window.
  3. Click left to place the dot.

Auto Dot Placement

Proteus will automatically place a dot whenever you route a wire off an existing wire such that there are then three wires meeting at that point. A junction dot can carry at most four wires.

The same mechanism operates when you run a wire onto a bus, although in that case you will not see the dot because it takes the colour and width of the bus.

See Also:

Wire and Bus Junctions

Auto Dot Removal

When a wire or wires are deleted, Proteus will detect where this leaves dots with two or no connected wires. Such dots are automatically removed unless the two wires that remain cannot legally be joined into one, for example where doing so would close a loop.