INTRODUCTION
Overview
The auto-router is one of the most powerful tools in the Proteus system and is capable of saving you an enormous amount of time and effort. The two principal technologies applied in the router are discussed below.
Shape Based Auto Routing
The router uses shape based routing algorithms. By contrast to traditional gridded maze autorouters, a shape based approach allows for more efficient use of routing area and is better suited to the complex design rule requirements of high density PCB designs.
Conflict Reduction Algorithms
In addition to its shape-based architecture, the router places routes with conflicts and then uses a multi-pass cost-based conflict reduction algorithm to find a routing solution adapting to the natural flow of the nets. On the initial passes the router uses a relatively low cost for accepting a routing path solution with crossing or clearance conflicts. Costings are then slowly increased on subsequent passes until all conflicts are removed. Because nets are allowed to be routed with conflicts at first, autorouted wires start out on an ideal path and the final routing solution closely mimics manual routing in terms of wire length and number of vias. This adaptive approach systematically reaches high completion rates on complex high density PCB designs.
In addition to the material below you may well find it useful to refer to the practical examples in the tutorial document.
See Also:
Advanced Auto-routing (Tutorial)
Modes of Operation
Despite the considerable internal complexity of the router, it is extremely easy to use in practice. There are three modes of operation, which can be thought of in simple terms as fully automated, scriptable and interactive. All three are discussed in more detail in subsequent topics.
Separately from these modes, the autorouter dialogue also offers Export Design File and Import Session File. These let you write the design out for an external router that reads the SPECCTRA design file format, and read the routed session back in again.
The Auto-Router and Design Rules
The auto-router is truly world class and can save you valuable hours of development time. However, it can only route with the guidelines you provide it and it stands to reason therefore that the more information you give the better the routing solution. Fortunately, Proteus also includes a comprehensive and flexible design rule system where you can specify a series of board constraints and clearances, trace widths and via styles for named net classes (e.g power, signal) and even the layers on which you wish given net classes to be routed on. All of these rules can be created and edited from the Design Rule Manager on the Technology Menu and will be honoured by Proteus when routing the board.
Whilst Proteus will quite happily route a board with the pre-supplied global design rule we strongly recommend you make use of the Design Rule Manager to specify constraints and information relevant to your particular project.
It is also extremely important to manage the placement of power planes onto designated plane layers. The auto-router will place vias to connect through to such planes whereas it will ignore power planes on signal layers for this purpose.
When working with Design Rooms the auto-router can only accept axis-aligned rectangular room definitions. A rotated rectangle or a polygonal room will be refused: the router does not start, and Proteus names the offending room so that you can find it. You can still create a polygonal design rule area in Proteus, but you will not then be able to auto-route the board.
See Also:
Design Rules and Net Classes (Tutorial)
Live Status Reporting
Once you have specified the required design constraints and invoked the autorouter, the status bar at the bottom of the editing window in Proteus reports progress as the router relays it, including the pass in progress and the percentage completion.
![]()
Routing progress reported on the status bar