LIMITATIONS

Overview

The auto-placer is a useful tool but there are a number of limitations of which you should be aware:

  • The board outline must form a closed path on the Edge layer. If it does not, the auto-placer reports an error and stops without placing anything.
  • Whilst the auto-placer can operate on boards on which some components have been pre-placed, the more of these there are, the less well it performs. If possible, it is better to let it place everything and then move things about afterwards. Pre-placing components in the middle of the board will cripple its performance, because this interferes with its ability to shuffle the components about as placement proceeds. Enabling Push & Shove lets the placer shuffle the components it has placed itself, but it cannot move parts you placed by hand, so a board with parts fixed in the centre will still place badly.
  • Boards which are decidedly non-rectangular also interfere with the Push & Shove mechanism and again the placer will perform badly in such cases. Boards with small cut-outs should not present a problem, however.

See Also:

Push & Shove

Using the Auto-placer