New Firmware Project
Overview
This is the firmware page of the New Project Wizard. It asks whether the project you are creating should carry firmware and, if it should, which processor it is written for and which toolchain builds it.

The New Firmware Project page of the wizard, with Create Firmware Project selected and the target and toolchain chosen.
Options
No Firmware Project
Creates the project without firmware. This is the right choice for a schematic or a layout that has no programmable part in it, and for a design whose processor already has a compiled binary you intend to attach by hand. You can add firmware to the project later.
Create Firmware Project
Creates a firmware project written in source code, which you edit and build in VSM Studio. Selecting this option enables the target and toolchain fields described below.
Create Flowchart Project
Creates a firmware project drawn as a flowchart rather than written as source code. The flowchart editor and its blocks are covered in the Visual Designer manual.
Target and Toolchain
Having chosen the kind of firmware project you want, you then specify what it is built for.
Family
The processor family, for example Arduino AVR or PIC18. Your choice here determines the controllers and the toolchains offered in the two fields below it.
Controller
The processor variant within the family. Only variants that Proteus can simulate are listed. Where your licence does not cover a variant it is shown but cannot be selected, and a message beneath the fields explains why.
Compiler
The toolchain used to build the firmware. Toolchains that VSM Studio has already found on your machine are listed first. A toolchain that is supported for the target but has not yet been located is listed below them and suffixed with (not configured); selecting one is allowed, but you will need to install and detect it before the project will build.
Compilers...
Opens the Compilers dialogue, from where you can download, install and detect a toolchain without leaving the wizard. Legacy toolchains are not offered in the Compiler list until they have been installed, and they are revealed for installation by the Show Legacy Compilers option on that dialogue.
Create Quick Start Files
Populates the new project with the starter sources the toolchain provides for the target you have chosen, so that you have something that compiles and runs from the outset. Clear this option if you intend to import your own sources instead. The option is unavailable where the selected toolchain supplies no quick start files.
Create Peripherals
Initialises the Labcenter peripheral drivers in the project, so that the prepared shields and breakout boards can be added from the peripheral gallery and bring their methods with them for you to drag into your code. With this option cleared you can still work with the target, but the drivers are not available. Clear it where you intend to use a third party library that provides its own drivers for the same parts.
Autoplace processor
Places the processor on the schematic for you, so that the design opens with the part already on the sheet. Clear this option if you would rather pick and place it yourself.
OK
Creates the project with the settings you have made.
Cancel
Abandons the wizard without creating a project.
The family and the toolchain are fixed when the project is created. Changing either of them afterwards means creating a new project, so it is worth being sure of both before you continue.
See Also: