TROUBLESHOOTING

Overview

When a simulation does not behave as you expected, the simulation log is where the explanation will be. This chapter describes the log itself and then works through the messages you are likely to find in it, in the order in which the stages that produce them run.

The title on the log window tells you which stage reported the trouble, and therefore which topic below to read.

The Simulation Log

What the log is, how to open it, how to read a message, and how to control what it records.

The Simulation Log

Netlisting Errors

Problems that stop a netlist being built from the schematic, reported under the title NETLIST COMPILER ERRORS.

Netlisting Errors

Linking Errors

Problems attaching a model to a part, reported under the title NETLIST LINKER ERRORS.

Linking Errors

Partitioning Errors

Problems dividing the circuit into the parts that need to be simulated, reported under the title PARTITION ANALYSER ERRORS.

Partitioning Errors

Power Rail Configuration Errors

Power nets that are not bound to a supply, and power rails that turn out to be wired together.

Power Rail Configuration Errors

Simulation Errors

Messages from the simulator itself, covering the analogue, digital and mixed mode failures, reported under the title SIMULATION ERROR LOG.

Simulation Errors

Convergence Problems

What to do when SPICE cannot solve the circuit at all.

Convergence Problems

See Also:

Diagnostic Tools

When a SPICE Model Will Not Simulate