ANALYSIS TYPES

Overview

There are thirteen types of graph available; each one displays the results of a different type of circuit analysis supported by PROSPICE:

ANALYSIS TYPES

DESCRIPTION

Analogue

Plots voltages and/or currents against time, much like an oscilloscope. Expressions involving several probe values can also be plotted: a current can be multiplied by a voltage, for example, to give a plot of instantaneous power. This mode of analysis is often referred to as Transient Analysis.

Digital

Plots logic levels against time, much like a logic analyser. Traces can represent single bits or the binary value of a bus. Digital graphs are computed using Event Driven Simulation.

Mixed Mode

Combines both analogue and digital signals on the same graph.

Frequency

Plots small signal voltage or current gains against frequency. This is also known as a Bode Plot, and both magnitude and phase can be displayed. With the use of Trace Expressions you can also produce input and output impedance plots. Note that plotted values are gains referenced to a specific input generator.

DC Sweep

Steady state operating point voltages or currents against a sweep variable. As with analogue analysis, expressions combining several probed values can also be plotted.

AC Sweep

Creates a family of frequency plots with one response for each value of the sweep variable.

Transfer

Plots characteristic curves or curve families by sweeping the value of one or two input generators and plotting steady state voltages and currents. The value of the first generator variable is plotted on the x-axis, and a separate curve is produced for each value of the second variable.

Noise

Input or output noise voltages against frequency. Also produces a listing of individual noise contributions.

Distortion

Plots the level of 2nd and 3rd harmonic distortion against frequency. Can also be used to plot intermodulation distortion.

Fourier

Shows the harmonic content of a transient analysis. This is much like connecting a spectrum analyser in place of an oscilloscope.

Audio

Performs a transient analysis and then plays the results through your sound hardware. Can also generate Windows WAV files from circuit output.

Interactive

Performs an interactive simulation and displays the results on a graph. This analysis type lets you combine the advantages of interactive and graph based simulation.

Conformance

Performs a digital simulation and then compares the results against a set of results stored from a previous run. This is especially relevant in creating software test suites for microcontroller based applications.

All of the analysis types listed here are part of the graph based simulation feature set. See Graph Based Simulation for the licensing position.

The Operating Point

Every analysis begins by computing the operating point of the circuit, that is the initial values of all node voltages, branch currents and state variables as at time zero. The remaining computation, whatever the analysis type, starts from that solution.

The time domain analyses let you defeat this step: the Initial DC solution option in the Options group of the transient, Fourier, audio, interactive and conformance graph dialogue forms is enabled by default and can be cleared. The frequency, sweep, transfer, noise and distortion analyses have no such option, because their mathematics depends on the operating point solution.

Information about the operating point is available on the schematic through a point and shoot interface. Pause the simulation, then right click a component or a wire and choose Operating Point Info. The command is only offered while the simulation is paused, and once the debugger has loaded it also becomes the default left click action for the object.

See Point and Shoot Parameter Information for the interactive equivalent.

Working With Results

Whatever the analysis type, the results of a run belong to the graph and are stored with the design. Two commands on the Graph menu operate on those results directly: Export Graph Data... writes the plotted data out to a file for use in another application, and Clear Graph Data... discards it, which is worth doing before you archive a design that carries a large capture.

See The Graph Menu for the full command list.

See Also:

Graph Based Simulation

Graph Objects

The Simulation Process